I purchased a kit and have it functional. I do have an issue. The control software crashes ALOT. Not sure what the issue is, but it seams be very fequent. Running it on a windows 11 pc, and the software boots fine but..... Any help would be appreciated!!!!!!
top of page
bottom of page
I have issues with the calibration, it will only run the first stage of calibration then stop. No messages are posted it just stops. I can then calibrate the remaining axes individually...??? Well it just drove past the J2 stop and crushed the end stop switch. I'll have to order new switches.
I'm not aware of any stability issues - can you tell me when its crashing? is it locking up and becoming unresponsive or does it close altogether?