Manual / kit fastener question - Questions https://anninrobotics.com/forum/questions/manual-kit-fastener-question/ Annin Robotics Discussion Board en-US Sat, 04 Apr 2026 15:44:05 +0000 wpForo 60 RE: Manual / kit fastener question https://anninrobotics.com/forum/questions/manual-kit-fastener-question/#post-2934 Sun, 10 Aug 2025 00:06:18 +0000 Thanks Chris. ]]> Questions Alastair Green https://anninrobotics.com/forum/questions/manual-kit-fastener-question/#post-2934 RE: Manual / kit fastener question https://anninrobotics.com/forum/questions/manual-kit-fastener-question/#post-2933 Sun, 10 Aug 2025 00:06:06 +0000 Hello, I've had some supply chain issues and depending on supplier I've had some batches of the rocker switch come with shorter wires. I have added a note to the manual to only extend them if they are shorter than 22cm. The issue on page 59 was a typo and I have corrected that as well. I apologize for the confusion on that.

]]> Questions Chris Annin https://anninrobotics.com/forum/questions/manual-kit-fastener-question/#post-2933 Manual / kit fastener question https://anninrobotics.com/forum/questions/manual-kit-fastener-question/#post-2931 Sun, 10 Aug 2025 00:05:41 +0000 Hi, I bought the full kit and have just finished getting J1 set up and have encountered a few issues I'd like to get some clarification on before I move on.

 

This one not a big deal but on page 55 just curious why we solder an extension to the red switch wire? I did this, then later when connecting it up to the driver it is too long so ended up just cutting it off again. What am I missing here?

 

Page 59 calls for #4 plastic thread form screws but my kit only has #6 thread form screws so I used them. Unfortunately looking ahead the build appears to require a total of 28 of these but the kit only supplies 26. Am I using the wrong fastener here then?

 

Thanks, Al

]]> Questions Alastair Green https://anninrobotics.com/forum/questions/manual-kit-fastener-question/#post-2931