M3 0.5 tap, lots of plastic wrap to protect bearings. Used wire in the blind hole to measure depth then added tape on the tap. Side: Chris w...

yes M3x10 (10mm overall, about 8mm of thread). I am wondering if hole is not threaded deep enough. Wont have access to metric tap till next week to te...

I had a bit of hand finish do to poor finish on the hub, but the pitches matched

You will also require a bunch of wiring, case, some tools. take a look at the bill of materials at the front of the wire harness, electrical enc...

Another Photo  1st-Day_2.webp