Thanks for clarifying Chris, I was wondering that myself.

I’m using a Prusa MK3S 3D printer ($750 kit) + ($25/spool of fillament) the build came out strong and very clean looking. So that’s my recommendation ...

Shipping time for the motors/drivers for me in TN took aprox. 2 weeks and $100 shipping - not happy about that.

You're welcome sir. Good luck!

Taking a few pics now of my J5 limit switch location to see if that'll help you position yours. (Make sure to leave a gap between the J5 limit switc...

I also had this problem with my build. What I did was have my girlfriend hold the J5 limit switch in place by hand (loosening the set screws) while ...

Oh I see now. So it looks as if your J5 limit switch roller is getting stuck on the aluminum frame of the housing? Is that it? Would it be possible ...

In the future, when you post pics, down by the blue "Answer" button there is a few icons. Simply click on the camera and your pics will upload to the ...

Nope, don't cut that off buddy. Give me one min. while I redo your pics.

I had a similar sounding issue as well but managed to correct it. Can you post a pic or two of your J5 limit switch and the housing setup?

If you haven't found a solution to your permission error, please take a look at the link below. I had the same com port permission error and was able ...

Oh, got it. Thank you sir.