same problem

yes, the encoder is working now.

@kstan-simit OK, i send the email to u

@kstan-simit It took me 5 hours to reconfirm each line. It shouldn’t be the wrong wiring. But really, I don’t know what went wrong or...

I'm really desperate. This system has a lot of bugs, and it can't present problems well. But the open source system is like this

@kstan-simit sure

In addition, what I want to ask is, after Teensy3.5 is set correctly (under normal working conditions), should there be a yellow-like light that is al...

@Kstan Simit Yes, all the lights are green, and when the stepper motor is connected and energized, I will not be able to move the arm by hand

Hi, Kstan, I Do these steps. e-stop, manual put position all 6 joint rest position switch to calibration tab, click "Calibrate @ Rest ...

please help me

After power on, I can’t move the joint manually, but after power off, I can move the joint by hand "beside, you not yet inform whether your J1-J...

all the way tried, the same issue

@chris-annin Hi Chris, The DM320T I purchased before was burnt out because of the wrong power connection. So, I use this DM320 to drive J4, so how do ...