@johann-voigtlander I ran the wire from the main electrical box all the way to the servo.

Hard to say for sure in your case, but I had to run my servo gripper in its own shielded cable for a clean signal, otherwise the servo would twitch.

I'm in Ontario and I paid $95 (CDN) at the door for the first 4 motors and drivers, then another $35 for the last two motors. They split the shipment ...

I'm in Ontario and I paid $95 (CDN) at the door for the first 4 motors and drivers, then another $35 for the last two motors. They split the shipment ...

@chris-annin The program now loads up for me. It will be a while until I can test it with the hardware, but I'll let you know if there are any issues....

Adding the timeout of 1 second worked for me. It runs 4 functions after this, each which do a serial read and then time out, so there is a 4 second pa...

I know what is going on, at least in my case. I do not have any hardware at all yet. I only just ordered the parts kit last week. What freezes the p...

I have spent all day trying to figure this out. I then got a bit desperate and just started commenting out little bits of code to see if something wou...

Anyone figure this out? I can't get the software to run on my main Windows 11 PC. I tried installing ttkthemese, pyserial, numpy and then pysintaller ...

I was looking at making some of the improvements you had listed, as well as a smooth ramp up and down in speed for accel/deccel. Excellent work so far...