← General Discussion

Good evening,it has been some time I put my AR4 MK3 together and only

Frank G@frankg· 1,143 viewsin General Discussion

Good evening,it has been some time I put my AR4 MK3 together and only now start trying to make some actual use of it rather than playing around...

I changed the gripper now to the pneumatic one to have a bit quicker reaction times and stronger grip but ran into some issues when programming it in the HMI. The manual does state to use:

Out On = 8 

and

Out Off = 8

to open and close the gripper. This seems not to be working though. Unless I am mistaken, it should be:

Set 5v Output # 8 = 0

and

Set 5v Output # 8 = 1

Tried this and it works well ;) ... 8 is the pin on the Nano as wiring is done the same as in the manual...

On an additional note, I had to remove the diode as it cut out my power supply . It seems to work without just fine without. 

Hope this helps someone else too.

All the best, 

Frank

Comment1

Chris Annin

Thank you for the feedback, you are correct in the latest software version the command should be Set 5v Output # 8 = 1 . I will get the manual updated to remove the older command with the current one.

Photos