← General Discussion

The table top is done and screwed to the cabinet. The AR3 bolted in

John Dammeyer@johndammeyer· 252 viewsin Robot Builds

The table top is done and screwed to the cabinet.  The AR3 bolted in place.  I found I needed a dedicated PC for it so I grabbed an old one that had LinuxCNC and installed WIN-10 and put what I hoped was the current working version of the AR4 software on it.  

Well yes and no.   I had forgotten I'd converted the encoders and steppers to match the AR4 but the rest of the system is still an AR3.   Couldn't remember what firmware was in the Teensy 4.1.  

Finally got it all working without stepper/encoder issues while jogging.

Comment2

John Dammeyer

Well crap! Seems joint 6 has a intermittent wiring issue losing encoder information from electrical noise or something. Swapped the encoder with one of the others. Problem did not move. Will swap a few other cables to test other possible reasons. Cables and wiring all show continuity with a meter. I really don't like these kinds of problems.

Josias López Hernández

Hi John, I had that exact same electrical noise issue a few days ago. I solved it by adding 10 nF ceramic decoupling capacitors between the encoder signal lines and GND.

Photos