← General Discussion
alyce lozano@alycelozano· 865 views

Question about Leadshine DM556 Stepper Motor Driver

Hello, I'm new to forum (and Arduino) so I hope I'm asking this correctly.

Does anyone have any advice/guidance for interfacing a UNO to a Leadshine DM556 driver? https://www.oyostepper.de/goods-1248-Leadshine-DM556-Digitaler-Stepper-Treiber-05-56A-20-50VDC-f%C3%BCr-Nema-17-23-24-Schrittmotor.html

I'm planning to use a NEMA 34 motor to drive the Z-axis on small mill. No positioning, just want to control speed and direction.

Comment1

luporest Lupu

Recommend to use esp32 and fluidNC and you will have the interface of mill in a web browser.

all informations you need http://wiki.fluidnc.com/en/installation

Photos