Annin Robotics
CommunityShop kits
← General Discussion
Joseph Puzzo@josephpuzzo· 505 views

J5 Tension Bearing gets stuck

Hello,

So im confused about the design of the J5 tention bearing. when you "Secure the bearing post and bearing to the J5 tension block using (1) M4x14 socket head cap screw as shown" the bearing can no longer spin. Am I doing something wrong ?

Comment 7

Johann Voigtlander

Did you put the 3D printed spacer on?

Joseph Puzzo

I did put the spacer. When i tighten the bolt even slightly it stops the bearing from being able to rotate

Joseph Puzzo

Nevermind IT was upside down lol

Joseph Puzzo

Actually it was not. turns out my spacer was a little too thick

Johann Voigtlander

Could it be upside-down?

I finished my build awhile ago, can't remember exactly.

Joseph Puzzo

Nope its not upside down. Maybe the bolt just needs to be loose 🤔

Cody S

Mine was too. I had to sand down a layer or so on my print

7 replies

Photos