End of arm tooling

Robot Arm Gripper Kits: Servo or Pneumatic?

The gripper is where a robot meets the work. The AR4 has two gripper parts kits, both documented in the build manual. Here is how they compare and what you need for each.

AR4 servo gripper assembled on the robot wrist

Two options

A servo gripper built around a 25 kg DS3225 servo with current sensing, or a pneumatic parallel gripper switched by a 24 V solenoid valve. Both connect through the Arduino Nano I/O board.

Servo kit

$74.50

Pneumatic kit

$139

Control

Arduino Nano

Manual

Ch. 4 and 5

Servo vs pneumatic

AR4 gripper parts kits
PriceServo $74.50; pneumatic $139
ActuatorServo: DS3225 25 kg servo. Pneumatic: MHF2-8D1 parallel gripper
PowerServo: 5 V 3 A supply (included). Pneumatic: 24 VDC brick for the valve (not included)
AirServo: none. Pneumatic: your own small compressor and regulator
ControlServo: Nano servo output, any position. Pneumatic: Nano relay switching a single coil 5 way valve, open or closed
ProtectionServo: ACS712 current sensor to detect a stall
Printed partsServo kit: fingers and covers not included

Building and wiring

Chapters 4 and 5 of the build manual cover each gripper: parts lists, assembly, routing the tubing or cable through the arm, and wiring to the Nano and relay.

Controlling the gripper

  • HMI: add servo or output commands to a program, with waits so the gripper settles before the arm moves.
  • Python API: nano.gripper_open() (servo position 45), nano.gripper_close() (position 0), nano.servo_write() for other positions, and nano.test_gripper_amps() to read the current sensor.
  • ROS 2: the driver exposes a gripper action; overcurrent protection can be enabled in its configuration when the current sensor is fitted.

Custom tooling

The Nano sketch drives up to 8 servos and 8 digital outputs and reads up to 8 inputs, so you can add vacuum, a second gripper, sensors or a tool changer. Count the tool's weight against the 1.9 kg payload. For a stepper driven gripper, use an additional axis.

Kit plus motors

$1,928

Combo kit $1,229 + StepperOnline motor package $699. Grippers and printed covers are extra.

FAQ

Which gripper should I choose for the AR4?

The servo gripper needs no air, runs from a 5 V supply and is easy to control in small steps. The pneumatic gripper is stronger and faster but needs a compressor and switches fully open or closed through a solenoid valve.

What comes in the servo gripper parts kit?

The $74.50 kit includes the servo, an Arduino Nano, breakout board, current sensor, power supply, cables, wires and hardware. Print the fingers and covers yourself or buy printed parts.

What comes in the pneumatic gripper parts kit?

The $139 kit has the main components to add a pneumatic gripper. The 24 VDC power brick (the same one the robot uses) and an air compressor are not included.

How do I control the gripper?

Both grippers run from the Arduino Nano I/O board: a servo output for the servo gripper, or a relay that switches the solenoid valve for the pneumatic one. Control them from HMI programs, the Python API or ROS 2.

Can I use my own gripper?

Yes. The Nano sketch drives up to 8 servos and 8 digital outputs and reads 8 inputs at 5 V, so most hobby servos and 24 V devices through a relay can be wired in. A stepper gripper can also run as an additional axis.